User's Manual

Avaya Branch Gateway Manager 10.0 Page 279
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: User
5.7.5 Source Numbers
This form is used to enter values that have special usages. These are entered using the Add, Edit and Remove buttons.
Usability
· Mergeable: These settings are mergeable. Changes to these settings do not require a reboot of the system.
Standard User Source Numbers
The following types of record can be added to a user's source numbers:
· V<Caller's ICLID>
Strings prefixed with a V indicate numbers from which access to the users mailbox is allowed without requiring entry of
the mailbox's voicemail code. This is referred to as "trusted source".
· For Standalone Voice Mail running in Intuity mode, trusted source is used for calls from programmable buttons set to
Voicemail Collect and Visual Voice. Other controls are prompted for the mailbox number and then password.
· R<Caller's ICLID>
To allow Dial In/RAS call access only from a specified number prefix the number with a "R", for example
R7325551234.
· H<Group Name>
Allows the user to receive message waiting indication of new group messages. Enter H followed by the group name, for
example HMain.
· On suitable display extensions, the hunt group name and number of new messages is displayed. Refer to the
appropriate telephone user guide.
· If the user is not a member of the group, a voicemail code must be set for the group's mailbox. See Voicemail Code
on the Hunt Group | Voicemail tab.
· P<Telephone Number>
This record sets the destination for callback (outbound alert) calls from voicemail. Enter P followed by the telephone
number including any necessary external dialing prefix, for example P917325559876. This facility is only available
when using Standalone Voice Mail through which a default Callback or a user specific Callback start point has been
configured. Refer to the Standalone Voice Mail documentation. This feature is separate from voicemail ringback and
Standalone Voice Mail outcalling.
· AT<string>
Strings beginning with AT can be used with a user called DTEDefault to configure the default settings of the control
unit's DTE port.
· Enable_OTT
Enable one touch transfer operation for the user.
NoUser User Source Numbers
The following source numbers can also be used on the Source Numbers tab of the NoUser user. These affect all
users on the system. Note that changes to these source numbers require a reboot of the system to become effective.
· DISTINCT_HOLD_RINGBACK
Used to display a specific message about the call type for calls returning after timing out from being parked or held. If
set, such calls display Return Call - Held or Return Call – Parked rather than connected party name or line name.
· FORCE_HANDSFREE_TRANSFER
If set, when using the handsfree announced transfer process, both the transfer enquiry and transfer completion
calls are auto-answered. Without this setting only the transfer enquiry call is auto-answered.
· HIDE_CALL_STATE
Used to hide the call status information, for example Dial, Conn, etc, on DS phones. Used in conjunction with the
LONGER_NAMES option. Not supported for 1600 and 9600 Series phones.
· LONGER_NAMES
Used to increase the length of names sent for display on DS phones. See Caller Display . Not supported for 1600
and 9600 Series phones.
· NO_DIALLED_REF_EXTERNAL
On outgoing external calls made using short codes to dial the full number, only the short code dialed is displayed on
the dialing user's phone and any directory matching is based on that number dialled. On systems with this source
number added to the configuration, after dialing a short code the full number dialled by that short code is shown and
directory matching is based on that full number.
322
764
743
762
730