User's Manual

Avaya Branch Gateway Manager 10.0 Page 217
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: Line
5.4.6.2 Channels
The settings for each channel can be edited. Users have the option of editing individual channels by double-clicking on
the channel or selecting and editing multiple channels at the same time. Note that the Line Appearance ID cannot be
updated when editing multiple channels.
When editing a channel or channels, the settings available are displayed on two sub-tabs; T1 Edit Channel and Timers.
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
T1 Edit Channel Sub-Tab Settings
· Channel
Allocated by the system.
· Incoming Group ID: Default = 0, Range 0 to 99999.
The Incoming Group ID to which a line belongs is used to match it to incoming call routes in the system configuration.
The matching incoming call route is then used to route incoming calls. The same ID can be used for multiple lines.
· Outgoing Group ID: Default = 0, Range 0 to 99999.
Short codes that specify a number to dial also specify the line group to be used. The system will then seize a line with
a matching Outgoing Group ID. The same ID can be used for multiple lines.
· Line Appearance ID: Default = Auto-assigned. Range = 2 to 9 digits.
Used for configuring Line Appearances with button programming. The line appearance ID must be unique and not
match any extension number. Line appearance is not supported for trunks set to QSIG operation and is not
recommended for trunks be used for DID.
· Direction: Default = Bothway
The direction of calls on the channel (Incoming, Outgoing or Bothway).
· Bearer: Default = Any
The type of traffic carried by the channel.
· Type: Default = Out of Service
The T1 emulates the following connections (Ground-Start, Loop-Start, E&M - TIE, E&M - DID, E&M Switched
56K, Direct Inward Dial, Clear Channel 64K or Out of Service). Trunks set to E&M - DID will only accept
incoming calls.
· If E&M - TIE is selected and the Outgoing Trunk Type is set to Automatic, no secondary dial tone is provided for
outgoing calls on this line/trunk.
· Dial Type: Default = DTMF Dial
Select the dialing method required (DTMF Dial or Pulse Dial).
· Incoming Trunk Type: Default = Wink-Start
Used for E&M types only. The handshake method for incoming calls (Automatic, Immediate, Delay Dial or Wink-
Start).
· Outgoing Trunk Type: Default = Wink-Start
Used for E&M types only. The handshake method for outgoing calls (Automatic, Immediate, Delay Dial or Wink-
Start).
· If the line Type is set to E&M-TIE and the Outgoing Trunk Type is set to Automatic, no secondary dial tone is
provided for outgoing calls on this line/trunk.
· Tx Gain: Default = 0dB
The transmit gain in dB.
· Rx Gain: Default = 0dB
The receive gain in dB.