User's Manual

Avaya Branch Gateway Manager 10.0 Page 210
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
5.4.4.3 Channels
This tab allows settings for individual channels within the trunk to be adjusted. To edit a channel either double-click on it
or click the channel and then select Edit.
To edit multiple channels at the same time, select the required channels using Ctrl or Shift and then click Edit. When
editing multiple channels, fields that must be unique such as Line Appearance ID are not shown.
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
· Line Appearance ID: Default = Auto-assigned. Range = 2 to 9 digits.
Used for configuring Line Appearances with button programming. The line appearance ID must be unique and not
match any extension number. Line appearance is not supported for trunks set to QSIG operation and is not
recommended for trunks be used for DID. If the trunk Line Sub Type is set to ETSI CHI, outgoing line appearance
calls must use the correspond channel.
The following additional fields are shown for lines where the Line Sub Type is set to ETSI CHI.
· Incoming Group ID: Default = 0, Range 0 to 99999.
The Incoming Group ID to which a line belongs is used to match it to incoming call routes in the system configuration.
The matching incoming call route is then used to route incoming calls. The same ID can be used for multiple lines.
· Outgoing Group ID: Default = 0, Range 0 to 99999.
Short codes that specify a number to dial also specify the line group to be used. The system will then seize a line with
a matching Outgoing Group ID. The same ID can be used for multiple lines.
· Direction: Default = Bothways
Controls the direction of calls allowed on the channel. Options are Bothways, Incoming or Outgoing.
· Bearer: Default = Any.
Allows selection of the type of call that can use the channel. Options are Any, Data or Voice.
· Admin: Default = Out of Service.
This field can be used to indicate whether the channel is in use or not. On trunks where only a limited number of
channels have been requested from the trunk provider (known as sub-equipped trunks), those channels not provided
should be set as Out of Service. For channels that are available but are temporarily not being used select
Maintenance.
· Tx Gain: Default = 0dB. Range = -10dBb to +5dB.
The transmit gain in dB.
· Rx Gain: Default = 0dB. Range = -10dBb to +5dB.
The receive gain in dB.