User's Manual

Avaya Branch Gateway Manager 10.0 Page 201
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: Line
5.4.3 BRI Line
BRI trunks are provided by the installation of a BRI trunk card into the control unit. The cards are available in
different variants with either 2 or 4 physical ports. Each port supports 2 B-channels for calls. For full details of
installation refer to the Avaya Branch Gateway Installation manual.
Point-to-Point or Multipoint
BRI lines can be used in either Point-to-Point or Point-to-Multipoint mode. Point-to-Point lines are used when only one
device terminates a line in a customer's office. Point-to-Multipoint lines are used when more than one device may be
used on the line at the customer's premises. There are major benefits in using Point-to-Point lines:-
1.The exchange knows when the line/terminal equipment is down/dead, thus it will not offer calls down that line. If
the lines are Point-to-Multipoint, calls are always offered down the line and fail if there is no response from the
terminal equipment. So if you have two Point-to-Multipoint lines and one is faulty 50% of incoming calls fail.
2.You get a green LED on the Control Unit when the line is connected. With Point-to-Multipoint lines some exchanges
will drop layer 1/2 signals when the line is idle for a period.
3.The timing clock is locked to the exchange. If layer 1/2 signals disappear on a line then the Control Unit will switch
to another line, however this may result in some audible click when the switchover occurs.
The system's default Terminal Equipment Identifier (TEI) will normally allow it to work on Point-to-Point or Point-to-
Multipoint lines. However if you intend to connect multiple devices simultaneously to an BRI line, then the TEI should be
set to 127. With a TEI of 127, the control unit will ask the exchange to allocate a TEI for operation.
Note: When connected to some manufactures equipment, which provides an S0 interface (BRI), a defaulted Control Unit
will not bring up the ISDN line. Configuring the Control Unit to a TEI of 127 for that line will usually resolve this.