User's Manual

Avaya Branch Gateway Manager 10.0 Page 200
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
· Inter-Digit Pause: Default = 500ms. Range = 0 to 2550ms.
Sets the pause between digits transmitted to the line.
· Ring Detection
· Ring Persistency: Default = Set according to system locale. Range = 0 to 2550ms.
The minimum duration of signal required to be recognized.
· Ring Off Maximum: Default = Set according to system locale. Range = 0 to 25500ms.
The time required before signaling is regarded as ended.
· Disconnect Clear
Disconnect clear (also known as 'Line Break' or 'Reliable Disconnect') is a method used to signal from the line provider
that the call has cleared. The system also uses 'Tone Disconnect', which clears an analog call after 6 seconds of
continuous tone, configured through the Busy Tone Detection (System | Telephony | Tones & Music )
settings.
· Enable: Default = On
Enables the use of disconnect clear.
· Units: Default = 500ms. Range = 0 to 2550ms.
This time must be less than the actual disconnect time period used by the line provider by at least 150ms.
· If the Unsupervised Analog Trunk Disconnect Handling setting (System | Telephony | Telephony ) is
enabled, this setting is greyed out and disconnect clear disabled..
· DTMF
These settings are used for DTMF dialing.
· On: Default = 40ms. Range = 0 to 255ms.
The width of the on pulses generated during DTMF dialing.
· Off: Default = 60ms. Range = 0 to 255ms.
The width of the off pulses generated during DTMF dialing.
· BCC Flash Pulse Width: [Brazil locale only] Default = 100 (1000ms). Range = 0 to 255.
Sets the BCC (Block collect call) flash pulse width.
· Gains:
These settings are used to adjust the perceived volume on all calls.
· A | D: Default = 0dB. Range =-10.0dB to +6.0dB in 0.5dB steps.
Sets the analog to digital gain applied to the signal received from the trunk by the system. To conform with the
Receive Objective Loudness Rating at distances greater than 2.7km from the central office, on analog trunks a
receive gain of 1.5dB must be set.
· D | A: Default = 0dB. Range =-10.0dB to +6.0dB in 0.5dB steps.
Sets the digital to analog gain applied to the signal from the system to the trunk.
· Voice Recording: Default = Low
Used to adjust the volume level of calls recorded by voicemail. Options are Low, Medium and High.
163 163
161