User's Manual

Avaya Branch Gateway Manager 10.0 Page 197
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: Line
5.4.2.1 Line
This tab covers general settings for an analog line.
Usability
· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.
Configuration Settings
· Line Number
This parameter is not configurable, it is allocated by the system.
· Card/Module:
Indicates the card slot or expansion module being used for the trunk device providing the line. 1 to 4 match the slots
on the front of the control unit from left to right. Expansion modules are numbered from 5 upwards, for example
trunks on the module in Expansion Port 1 are shown as 5.
· Port:
Indicates the port on the Card/Module above to which the configuration settings relate.
· Network Type: Default = Public.
This option is available if Restrict Network Interconnect (System | Telephony | Telephony ) is enabled. It
allows the trunk to be set as either Public or Private. The system will return number unobtainable indication to any
attempt to connect a call on a Private trunk to a Public trunk or vice versa. This restriction includes transfers,
forwarding and conference calls.
· Telephone Number
Used to remember the external telephone number of this line to assist with loop-back testing. For information only.
· Incoming Group ID: Default = 0, Range 0 to 99999.
The Incoming Group ID to which a line belongs is used to match it to incoming call routes in the system configuration.
The matching incoming call route is then used to route incoming calls. The same ID can be used for multiple lines.
· Outgoing Group ID: Default = 0, Range 0 to 99999.
Short codes that specify a number to dial also specify the line group to be used. The system will then seize a line with
a matching Outgoing Group ID. The same ID can be used for multiple lines.
· Outgoing Channels: Default = 1 (not changeable)
· Voice Channels: Default = 1 (not changeable)
· Prefix: Default = Blank
Enter the number to prefix to all incoming numbers for callback. This is useful if all users must dial a prefix to access
an outside line. The prefix is automatically placed in front of all incoming numbers so that users can dial the number
back.
· For outgoing calls: PreThe system does not strip the prefix, therefore any prefixes not suitable for external line
presentation should be stripped using short codes.
· National Prefix: Default = 0 (not changeable)
· Line Appearance ID: Default = Auto-assigned. Range = 2 to 9 digits.
Allows a number to be assigned to the line to identify it. On phone's that support call appearance buttons, a Line
Appearance button with the same number will show the status of the line and can be used to answer calls on the line.
The line appearance ID must be unique and not match any extension number.
· Admin: Default = In Service.
This field allows a trunk to be taken out of service if required for maintenance or if the trunk is not connected.
159 159