User's Manual

Avaya Branch Gateway Manager 10.0 Page 182
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
5.3.11 Twinning
These settings are used with Mobile Twinning, see the User | Mobility tab for further details.
· Outgoing CLI Warning
Changing the outgoing CLI for calls requires the line provider to support that function. You must consult with
your line provider before attempting to change the outgoing CLI, failure to do so may result in loss of service.
If changing the outgoing CLI is allowed, most line providers required that the outgoing CLI used matches a
number valid for return calls on the same trunks. Use of any other number may cause calls to be dropped or
the outgoing CLI to be replaced with a valid number.
· On mobile twinned calls, if the original party information is used or a specific calling party information CLI is
set, that number overrides setting the outgoing CLI using short codes.
Usability
· Mergeable: These settings are mergeable. Changes to these settings do not require a reboot of the system.
Configuration Settings
· Send Original Party Information for Mobile Twinning: Default = Off
When on, the system will attempt to send the ICLID information provided with the incoming call to the twinning
destination.
· The values on the System | Twinning tab override the SIP lines Send Caller ID setting.
· Calling Party Information for Mobile Twinning: Default = Blank (Disabled). Range = Up to 32 digits.
This field is usable when Send Original Party Information for Mobile Twinning is off. Note that the number
entered here for use as the CLI must be a valid number for return calls to the same site. Some line providers may
reject calls that use a number that is not valid for return calls to the same site. In addition depending on the line type
and line provider settings the maximum number of digits may be limited.
295
182