User's Manual

Avaya Branch Gateway Manager 10.0 Page 181

15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway

Configuration Settings: System

5.3.10 SMDR

Using a specified IP address, the system can send a call record for each completed call.

Usability

Mergeable: Pre-3.2 , 3.2+ .

Configuration Settings

· Output: Default = No Output.

Select the type of call record that the system should output via IP.

· No Output

· SMDR Only:

Send call records using the SMDR settings below.

SMDR Configuration Settings

These settings are shown if SMDR Only is selected as the Output. For further details refer to Appendix: SMDR .

· IP Address: Default = 0.0.0.0 (Listen).

The destination IP address for SMDR records.

· The address 0.0.0.0 puts the control unit in listen mode on the specified TCP port. When a connection is made on

that port, all SMDR records in the buffer are provided.

· TCP Port: Default = 0.

The destination IP port for SMDR records.

· Records to Buffer: Default = 500. Range = 10 to 3000.

The system can cache up to 3000 SMDR records if it detects a communications failure with destination address. If the

cache is full, the system will begin discarding the oldest records for each new record.

· Call Splitting for Diverts: Default = Off.

When enabled, for calls forwarded off-switch using an external trunk, the SMDR produces separate initial call and

forwarded call records. This applies for calls forwarded by forward unconditional, forward on no answer, forward on

busy, DND or mobile twinning. It also applies to calls forwarded off-switch by an incoming call route. The two sets of

records will have the same Call ID. The call time fields of the forward call record are reset from the moment of

forwarding on the external trunk. For full details see SMDR Call Records .

850