User's Manual

Avaya Branch Gateway Manager 10.0 Page 180

15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway

5.3.9 SMTP

SMTP can be used as the method of sending system alarms. The email destination is set as part of the email alarms

configured in System | System Events | Alarms .

SMTP can be used with Embedded Voicemail for Voicemail Email . The voicemail destination is set by the user's

Voicemail Email address.

Usability

· Mergeable: These settings are not mergeable. Changes to these settings will require a reboot of the system.

Configuration Settings

· IP Address: Default = 0.0.0.0

This field sets the IP address of the SMTP server being used to forward SNMP alarms sent by email.

· Port: Default = 25. Range = 0 to 65534.

This field set the destination port on the SMTP server.

· Email From Address: Default = Blank

This field set the sender address to be used with mailed alarms. Depending of the authentication requirements of the

SMTP server this may need to be a valid email address hosted by that server. Otherwise the SMTP email server may

need to be configured to support SMTP relay.

· Server Requires Authentication: Default = On

This field should be selected if the SMTP server being used requires authentication to allow the sending of emails.

When selected, the User Name and Password fields become available.

· User Name: Default = Blank

This field sets the user name to be used for SMTP server authentication.

· Password: Default = Blank

This field sets the password to be used for SMTP server authentication.

· Use Challenge Response Authentication (CRAM-MD5): Default = Off.

This field should be selected if the SMTP uses CRAM-MD5.

177

274