User's Manual

Avaya Branch Gateway Manager 10.0 Page 179
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Configuration Settings: System
Type
Events
Event State
Message
Free Capacity
Generic
Generic
Non-primary location boot
alarm
System running backup software.
Invalid SD Card
Incompatible or Invalid (System or
Optional) SD Card fitted.
Network link failure
Network Interface name (ip address)
has been disconnected.
Network link operational
Network Interface name (ip address)
has been connected.
System warm start
System has been restarted (warm
start).
System cold start
System has restarted from power fail
(cold start).
SNMP Invalid community
Invalid community specified in SNMP
request.
License
License Server
Server operational
The license server is now operational.
Server failure
The license server is no longer
operational.
License Key Failure
License Key Failure
Loopback
Loopback
Near end line loopback
Trunk number (name) [on expansion
module number] is in near end
loopback.
Near end payload loopback
Trunk number (name) [on expansion
module number] is in near end
loopback with payload.
Loopback off
Trunk number (name) [on expansion
module number] has no loopback.
Phone Change
Phone Change
Phone has been unplugged
The phone with id n has been removed
from extension extension (unit, port
number).
Phone has been plugged in
The phone with type type (id number)
has been plugged in for extension
extension (unit, port number).
Quality of Service
QoS Monitoring
If Enable RTCP Monitor on Port 5005 is selected, any monitored
calls that exceeds the set QoS Parameters will cause an alarm.
Syslog
Basic Audit
Events as written to the system Audit Trail. Available on Syslog output
only.
System
Configuration
–
–
Small Community Network dial
plan conflict
Small Community Network dial plan
conflict
No incoming call route for call
The following line had no Incoming Call
Route for a call. Line: <number> or
Line Group ID: <number>.
Installed hardware failure
Installed hardware failure details will be
provided.
System Shutdown
Running Backup
· Standalone Voice Mail Storage Alarms
The alarm threshold is adjustable through the Standalone Voice Mail client.
· Embedded Voicemail Storage Alarms
A disk full alarm is generated when the Embedded Voicemail memory card reaches 90% full. In addition a critical
space alarm is generated at 99% full and an OK alarm is generated when the disk space returns to below 90%
full.
· Loopback
This type of alarm is only available for systems with a United States locale.
147
176