User's Manual

Avaya Branch Gateway Manager 10.0 Page 164
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
· Busy Tone Detection: Default = System Frequency (Tone defined by system locale)
Allows configuration of the system's busy tone detection settings on lines that do not provide reliable disconnect
signalling. In that case, the system will use tone disconnect clearing to disconnect such lines after 6 seconds of
continuous tone. The default tone (frequency and on/off cadence) detection used is defined by the system locale .
The settings should not be adjusted unless advised by Avaya Technical Support. Changes to this setting require a
reboot rather than a merge when the new configuration is sent to the system.
· Hold Music
This section is used to define the source for the system's music on hold source. You must ensure that any MOH source
you use complies with copyright, performing rights and other local and national legal requirements. For full details of
music on hold configuration, see Music on Hold .
· System Source: Default = WAV File.
Selects the default hold music source for most uses of music on hold. For pre-Release 6.x systems, changes to this
setting require a reboot.
· WAV File:
Use the WAV file holdmusic.wav. This file is loaded via TFTP.
· External:
Use the audio source connected to the back of the control unit. This causes the system to not load the
holdmusic.wav file via TFTP when rebooted.
· Tone:
The use of a double beep tone (425Hz, 02./0.2/0.2/3.4 seconds on/off) can be selected as the system source.
The hold music tone is automatically used if the system source is set to WAV File but the holdmusic.wav
file has not yet been successfully downloaded.
· Alternate Sources:
Up to three additional hold music source can be specified. These are wav files loaded and stored in a similar way
to holdmusic.wav above. Note that adding and changing a source can be done using a merge but deleting a
source requires a reboot.
· Number
Assigned automatically by the system. The alternate sources are numbered 2, 3 and 4.
· Name: Up to 31 characters
This field is used to associate a name with the alternate source. That name is then used in the Hold Music
Source field on Incoming Call Routes and Hunt Groups.
· Source: Up to 31 characters
Defines the source for the music on hold.
· For a wav file, enter WAV: followed by the file name. For example, for the file holdmusic2.wav, enter
WAV:holdmusic2.wav. The system will automatically attempt to load that file via TFTP following a
reboot.
· Any analog extension with its Equipment Classification set as MOH Source can be entered as the
alternate source. Enter XTN: followed by the extension's Base Extension number. For example XTN:224.
796
740
260