User's Manual

Avaya Branch Gateway Manager 10.0 Page 131
15-601011 Issue 29r (Friday, November 02, 2012)B5800 Branch Gateway
Menu Bar Commands: Security Mode
4.5 Embedded File Management
For control units with a memory card installed, the contents of the card can be viewed using Branch Gateway Manager.
This view can also be used to add and remove files from the card. This may be useful when the memory card is being
used to store Music on Hold or IP phone firmware files. For Linux based systems access to the /opt/ipoffice folder is
provided.
· Embedded Voicemail Files
When viewing the memory card, the files related to Embedded Voicemail are visible, however these files are
greyed out (ie. cannot be deleted, downloaded or overwritten).
· Mailbox greetings and messages are shown as .clp files.
· The language prompts for Embedded Voicemail functions are stored in separate language sub-folders of
lvmail.
· Named prompt files for use by Embedded Voicemail auto attendants are stored in the lvmail\AAG folder and
use the same .c11 or .c23 file formats as the language prompts. These files can be created from standard .
wav files before being downloaded to the memory card by using the LVM Greeting Utility .
· Avaya IP Phone Files
The memory card can be used as the source of files requested by IP Phones when rebooting. For phones using
system DHCP, once the files are loaded onto the card, the TFTP Server IP Address and HTTP Server IP
Address on the System | System tab must be set to match the system's LAN address.
· Viewing a Memory Card
When Advanced | Embedded File Management is selected, the Branch Gateway Manager will go through
normal system discovery but will only allow selection of systems which can support a memory card. When a
system is selected, a valid service user name and password for configuration access to that system is requested. If
the system selected does not have a memory card installed, the files view remains blank and the message TFTP:
Received TFTP Error "Not Found" appears in Manager's status bar.
· Changing the Files View
The type of display used in the Files pane can be changed by selecting from the View menu in the toolbar.
119
140
140 140