Configuration manual

12. Click Save.
The B5800 Branch Gateway reboots.
Result
When the B5800 Branch Gateway is administered by System Manager, the following is
automatically configured:
• SNMP enabled
• SNMP trap destination 1 from System Manager IP address
• All SNMP traps active
• WebLM client active
• WebLM service address from System Manager IP address
• Remove all default extension users, leaving “NoUser” and “RemoteManager”
Additional features configured by the Initial Installation Utility
After you run the Initial Installation Utility, the following features are also configured:
• System Status Interface (SSA) service security level – Unsecure only
• Configuration service security level – Secure, Medium
• Security Administration service security level – Secure, Medium
• OAMP Web Services service security level – Secure, Low (if locally administered)
• OAMP Web Services service security level – Secure, High (if administered by System
Manager)
• Admin Client Certificate checks:-- High (if administered by System Manager)
• SCEP client active (if administered by System Manager)
• SCEP server IP address from SMGR IP address (if administered by System Manager)
• Legacy Program Code – Active (if locally administered)
Configuring the B5800 Branch Gateway for certificates
Before you begin
Generate a certificate on System Manager. See Generating a certificate on System
Manager on page 119.
Configuring the B5800 Branch Gateway for certificates
Implementing the Avaya B5800 Branch Gateway for an Avaya Aura
®
Configuration October 2012 123