Configuration manual

be 0 – 7. Note that because it is attenuation, the higher the value, the lower the
ring volume. For example, 0 is full volume.
8. In the Line Group Id drop-down box, accept the default value, 0.
9. In the Locale drop-down box, accept the default value, blank.
10. For the Force Account Code check box, accept the default value, unchecked.
11. Click OK.
The short code is displayed in the ShortCodes tab.
12. Repeat steps 3 through 11 for each user whose data programming you want to
preserve.
Remotely forcing a BST phone to return to default settings
About this task
Use this task to remove the DCP code to remotely force a BST phone to return to default button
programming and default contrast and ring volume settings for that set type.
Note:
Although calls currently active on the phone should not be affected, use caution when you
force a BST phone to return to default settings.
Procedure
1. Start Manager and connect to the B5800 Branch Gateway.
2. In the left navigation pane, click User.
3. Click the appropriate user and then click the ShortCodes tab.
4. Select the DCP short code and then click Remove.
For the BST phone currently connected to that user extension, the following occurs:
• Button programming per the BST phone model currently connected to that user
extension is returned to the default setting.
• BST phone contrast is returned to the default setting.
5. Click OK.
Note:
You can also use this procedure to reset a user extension so that the next time
a BST phone model of any type is connected to it, that user’s programming will
be defaulted appropriately to that BST phone.
About preserving staged button programming for BST phones
92 Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012
Comments? [e-mail]