Configuration manual

Procedure
1. Rename the music file holdmusic.wav.
2. Using a card reader, copy the file into the /system/primary folder on the System
SD memory card.
3. If the B5800 Branch Gateway system is configured for additional music-on-hold files
(up to 3 additional files), copy those files to the same location.
The name of the additional files must match those specified in the B5800 Branch
Gateway system configuration.
Base and trunk card installation
The base cards and trunk daughter cards should be fitted before power is applied to the control
unit. Ensure that cards are inserted in the order that matches the planned or pre-built
configuration. In general, the following applies to card installation:
• Cards can be fitted in any order into any available slots. The only exception is the 4-port
expansion card which can only be installed in right-hand slot 4.
• It is recommended that cards are fitted from left to right.
• There are restrictions to the number of supported cards of some types. When a limit is
exceed, the right-most card of that type will not function.
• Ensure that you use the labels supplied to identify the card fitted into the control unit.
Warning:
• Correct anti-static protection steps should be taken before handling circuit boards.
• Cards must never be added or removed from the control unit while it has power
connected.
Trunk daughter card preparation
Trunk daughter cards can be fitted to any base card except the legacy card carrier. For
combination cards, the trunk daughter card is pre-installed and cannot be changed.
Base and trunk card installation
Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 61