Configuration manual

on the control units can be used for system maintenance and connection of serial terminal
adaptors.
An asynchronous terminal program such as HyperTerminal is also required. Configure this for
operation via a PC serial port, as follows:
Bits per second 38,400 Parity None Flow Control None
Data bits 8 Stop Bits 1 Settings > Emulation TTY
DTE cables
These cables are used for system maintenance and diagnostics under Avaya guidance. They
can also be used for connection of RS232 serial terminal adaptor equipment to the control unit.
This cable is a "Straight through DB9 female to DB9 male serial cable."
9-Way RS232 DTE Port Signal PC/Terminal Adaptor
3 Receive data 3
2 Transmit Data 2
7 RTS (Request To Send) 7
8 CTS (Clear To Send) 8
6 DSR (Data Set Ready) 6
5 Ground 5
1 DCD (Data Carrier Detect) 1
4 DTR (Data Terminal Ready) 4
9 RI (Ring Indicator) 9
About erasing the configuration
The following procedures erase the B5800 Branch Gateway configuration stored in the control
unit. This includes both the current configuration being used in RAM memory and the backup
configuration stored in non-volatile memory. Following this, the B5800 Branch Gateway will
restart with a default configuration.
DTE port maintenance
Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 233