Configuration manual

Replacing a component with one of higher capacity

About this task

If you are replacing a component with one of the same type but with higher capacity, when

restarted the B5800 Branch Gateway system will automatically create configuration entries for

the new trunks or extensions/users.

Procedure

1. Turn the B5800 Branch Gateway system off. See

System shutdown on page 208.

2. Remove the card or external expansion module.

Note:

The card slot or expansion port used as the replacement must be installed in the

same position.

3. Install the replacement using the appropriate procedure for the type of component.

See

Base and trunk card installation on page 61 or Connecting external expansion

modules on page 72 for more information.

4. Restart the B5800 Branch Gateway system.

5. Use Manager to configure the new trunks or extension/users.

Replacing a component with one of lower capacity

About this task

If you are replacing a component with one of the same type but with lower capacity, when

restarted the B5800 Branch Gateway system configuration must be edited to remove

redundant entries.

Procedure

1. Turn the B5800 Branch Gateway system off. See System shutdown on page 208.