Configuration manual

launched on your PC. For more information, see Editing a B5800 Branch Gateway
system configuration from System Manager on page 159.
2. In the left navigation pane, click System.
3. Click the Voicemail tab.
4. In the Voicemail Type drop-down box, select Call Pilot.
Note:
Fields applicable to this mode of voicemail support remain enabled.
5. To enable the local B5800 Branch Gateway system features for Embedded
Voicemail auto attendants and announcements, in the Use embedded for AA and
Announcements drop-down box, select the appropriate embedded voicemail. The
announcements are those that the callers hear when the call in on hold.
Note:
You must also enable the announcements. Do this by selecting the check box for
Announcements On which appears when you select Hunt Group >
Announcements tab.
6. In the Phone Context field, enter the appropriate number, up to a maximum of 11
characters. This number is the CDP or UDP dial plan configured on CS 1000. This
number is included in the history information field of the SIP message to identify the
CallPilot mail box.
7. In the Call Pilot Number field, enter the extension number configured for mailbox
access to the Call Pilot system. Note that this number is automatically routed via
the active Avaya Aura
®
Session Manager line or the NRS SIP line. It does not need
to be routed through the normal branch call routing.
Note:
The Call Pilot PSTN Number field and associated Enable Voicemail
Instructions Using DTMF check box are disabled in R6.2. B5800 Branch
Gateway does not access the CallPilot system over the PSTN when the Session
Manager line is down.
8. In the Maximum Record Time field, use the up and down arrows to set the
maximum recording length in seconds for recorded announcement and auto
attendant prompts.
Note:
You can set a number in this field only if you selected one of the two embedded
voicemail options in the Use embedded for AA and Announcements drop-
down box.
9. In the VoiceMail Ports field, use the up and down arrows to set the number of
licensed voicemail ports.
10. Accept the default setting for Enable Voicemail Instructions Using DTMF.
Voicemail configuration
180 Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012
Comments? [e-mail]