Configuration manual

digits are not automatically sent. Instead, the caller will dial the user's mail box
number to manually send the required DTMF digits to access the mailbox.
9. In the Maximum Record Time field, use the up and down arrows to set the
maximum recording length in seconds for recorded announcement and auto
attendant prompts.
Note:
You can set a number in this field only if you selected one of the two voicemail
options in the Use embedded for AA and Announcements drop-down box.
10. In the VoiceMail Ports field, use the up and down arrows to set the number of
licensed voicemail ports.
Note:
You can set a number in this field only if you selected one of the two voicemail
options in the Use embedded for AA and Announcements drop-down box.
Avaya Aura Messaging requires SIP Trunk Session configuration and uses SIP
Trunk Sessions licenses.
11. Accept the default setting (on, that is check box is checked) for Enable Voicemail
Instructions Using DTMF.
12. Click OK.
13. Select File > Save Configuration.
The Send Configuration window appears and the Configuration Reboot Mode is set
to Immediate. Do not change the reboot mode.
Configuring B5800 Branch Gateway to use CallPilot for
voicemail
About this task
The B5800 Branch Gateway system can be configured to use CallPilot as its voicemail
server.
Note:
CallPilot and CS 1000 can be configured to send Message Waiting Indication (MWI) in a
SIP NOTIFY message to the B5800 Branch Gateway user. For more information, see
Configuring CallPilot and CS 1000 to send MWI in a SIP NOTIFY message to the user on
page 181.
Procedure
1. From the System Manager console, select the B5800 Branch Gateway device and
click Edit to edit the system configuration for the device. IP Office Manager will be
Configuring B5800 Branch Gateway to use CallPilot for voicemail
Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 179