Configuration manual

Name Range or Default Description
either RFC2833 or Inband.
Meeting Exchange does
not support digit exchange
through out-of band (that
is, Info) signaling.
Media Security Default = Disable Media security is not
required. All media sessions
(audio, video, and data) will
be enforced to use RTP
only.
Advanced This option provides
additional media security
options. These options are
not supported in B5800
Branch Gateway R6.2.
VoIP Silence Suppression Default = Off When selected, this option
will detect periods of silence
on any call over the line and
will not send any data during
those silent periods.
Allow Direct Media Path Default = On This setting controls whether
connected calls must remain
routed via the B5800 Branch
Gateway or can be routed
alternately if possible within
the network structure.
• If enabled, connected calls
can take routes other than
through the B5800 Branch
Gateway. This removes the
need for a voice
compression channel.
• If disabled or not supported
at one end of the call, the
call is routed via the B5800
Branch Gateway. However
RTP relay support allows
calls between devices
using the same audio
codec to not require a voice
compression channel.
Re-Invite Supported Default = On When enabled, Re-Invite can
be used during a session to
change the characteristics of
Initial branch configuration
150 Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012
Comments? [e-mail]