Configuration manual

Name Description
Outgoing Group ID The default setting is 99999. This value is not
changeable. However note the value as it is
used in B5800 Branch Gateway short codes
used to route calls to the Session Manager
or NRS.
Prefix This field is blank by default. This prefix will
be added to any source number received
with incoming calls.
Max Calls The default setting is 10. This value sets the
number of simultaneous calls allowed
between B5800 Branch Gateway and
Session Manager or NRS using this
connection. Each call uses one of the
available licenses that are shared by all SIP
trunks configured in the system.
URI Type When SIP or SIPS is selected in the drop-
down box, the SIP URI format is used (for
example, [e-mail]). This
affects the From field of outgoing calls. The
To field for outgoing calls will always use the
format specified by the short codes used for
outgoing call routing. Recommendation:
When SIP Secured URI is required, the URI
Type should be set to SIPS. SIPS can be
used only when Layer 4 Protocol is set to
TLS.
Layer 4 Protocol This can be set to TLS or TCP. Set to TLS to
choose SIPS as the URI Type when SIP
Secured URI is required. For deployments
that include NRS, set this field to TCP.
Send Port When Layer 4 Protocol is set to TLS, the
default setting is 5061. When Layer 4
Protocol is set to TCP, the default setting is
5060.
Listen Port When Layer 4 Protocol is set to TLS, the
default setting is 5061. When Layer 4
Protocol is set to TCP, the default setting is
5060.
Initial branch configuration
148 Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012
Comments? [e-mail]