Configuration manual

e. In the Device Certificate Name field, enter the appropriate certificate authority
name.
Note:
The device certificate name cannot contain spaces.
f. In the Certificate Enrollment (SCEP) Password field, enter the appropriate
password.
12. Click Save.
The B5800 Branch Gateway reboots.
Result
When the B5800 Branch Gateway is administered by System Manager, the following is
automatically configured:
• SNMP enabled
• SNMP trap destination 1 from System Manager IP address
• All SNMP traps active
• WebLM client active
• WebLM service address from System Manager IP address
• Remove all default extension users, leaving “NoUser” and “RemoteManager”
Additional features configured by the Initial Installation Utility
After you run the Initial Installation Utility, the following features are also configured:
• System Status Interface (SSA) service security level – Unsecure only
• Configuration service security level – Secure, Medium
• Security Administration service security level – Secure, Medium
• OAMP Web Services service security level – Secure, Low (if locally administered)
• OAMP Web Services service security level – Secure, High (if administered by System
Manager)
• Admin Client Certificate checks:-- High (if administered by System Manager)
• SCEP client active (if administered by System Manager)
• SCEP server IP address from SMGR IP address (if administered by System Manager)
• Legacy Program Code – Active (if locally administered)
Using the Initial Installation Utility
Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 123