Configuration manual

# Description Section
9 Create a system template. (Optional) See Creating a system template on
page 131.
10 Upload an auto attendant audio file.
(Optional)
See Uploading an auto attendant audio
file on page 132.
11 Apply the system template to one or
more branches. (Optional)
See Applying the system template on
page 133.
12 Create an endpoint template. See Creating an endpoint template on
page 133.
Note:
You must create a B5800 Branch
Gateway endpoint template. You cannot
add a user in System Manager unless an
endpoint template has been created.
Note:
• Steps 13 through 24 are performed to modify a B5800 Branch Gateway
configuration as needed.
• Steps 25 through 32 are performed to configure Avaya Aura
®
Session
Manager.
• Step 33 is performed to configure B5800 Branch Gateway users from User
Management within System Manager.
13 Disable unused trunks. See Disabling unused trunks on
page 135.
14 Set a trunk clock quality setting. See Setting a trunk clock quality setting on
page 137.
15 Set trunk prefixes. See Setting the trunk prefixes on
page 138.
16 Enable SIP trunk support. See Enabling SIP trunk support on
page 140.
17 Set the branch prefix and local
number length for the extension
numbering.
See Setting the branch prefix and local
number length for extension numbering on
page 141.
18 Change the default codec selection. See Changing the default codec
selection on page 144.
19 Change the maximum SIP sessions. See Changing the maximum SIP
sessions on page 145.
20 Add a Session Manager line. See Adding an Avaya Aura Session
Manager line on page 146.
Configuration checklist
Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 109