User's Manual

Dec 12, 2013 11:34 AM

Issue Description

932240

When we configure the B189 phone to backup/restore using HTTP

credential, after the phone comes up from reboot and if we want to

preform backup/restore, the phone shows status screen for credential

values.

Two lines for user and password are part of credential screen.

When user presses user/password screen a keyboard is displayed.

If user presses on one of the application buttons, the credential screen

will disappear and the phone will not get dial tone.

You should use only the red X button or the green V button to close the

keyboard.

Workaround:

Go to Settings screen, press "About Avaya IP Conference Phone" and

then press on "Back" soft key, this will display the HTTP Authentication

screen again.

5341908

When using serial cable to connect to the phone from PC, set PC serial

client to the following settings:

Speed = 115200

Data bits = 8

Stop bits = 1

Parity = None

Flow control = None

722253

When using “Guest login” to B189 from 96x1 9608 or 9611 phone htat

is configured with half width ("Phone Screen Width") and performing

backup, “Phone Screen Width” parameter will disappear from the

backup file.

321725

Call Server parameter in ADD does not update after changing from an

extension to another extension on different CM’s

Work around: Check Call Server in MENU-> Network Info-> IP

Parameters before check call server Administration->ADD mode, phone

will display parameter correctly

752255

In some cases after canceling confirmation pop-up (reset, clear values)

the application buttons will be available in Administration menu. If the

administrator uses it to exit CRAFT the phone will not get dial tone.

Workaround:

1. Exit Administration Menu only by using the back button.

2. In case of hitting the applications button and exiting Administration

menu,

enter Administration menu again exit via the “Back” button.