Datasheet

To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Caution:
Risk of equipment damage
Only trained personnel can install this product.
Procedure steps
1. Remove the SFP from its protective packaging.
2. Grasp the SFP between your thumb and forefinger.
3. As shown in the following figure, insert the device into the slot on the module.
Caution:
Risk of equipment damage
SFPs are keyed to prevent incorrect insertion. If the SFP resists pressure, do not
force it; turn it over, and reinsert it.
Apply a light pressure to the device until it clicks and locks into position.
4. Remove the dust cover from the optical bore and insert the fiber optic connector.
Job aid
Depending on the transceiver manufacturer, your SFP transceiver can have various types of
locking and extractor mechanisms.
The following figures shows a typical mechanisms used on SFP transceivers; other locking
and extractor mechanisms exist, although they are not shown here. In the following figure, the
SFP still has the bore plug installed. Pull the bail to release the device.
Installing an SFP
Installation — SFPs and XFPs December 2010 23