Release Notes

No stack-monitor command

The no stack-monitor command disables the Stack Monitor feature.

The syntax for the no stack-monitor command is:

No stack-monitor or

no stack-monitor enable

The no stack-monitor command is in the config command mode.

The no stack-monitor command does not have any parameters or variables.

Stack Monitor tab (JDM version 5.9.5)

To open the Stack Monitor tab:

1 Select the chassis.

2 From the shortcut menu, choose Edit > Chassis.

The Chassis dialog box opens with the System tab displayed.

3 Click the Stack Monitor tab.

The Stack Monitor tab opens.

Figure 1 Stack Monitor tab

Table 3 describes the Stack Monitor tab fields.

Table 3 Stack Monitor tab fields

Field Description

StackErrorNotificationEnabled

Enables or disables the Stack Monitoring feature.

ExpectedStackSize

Sets the size of the stack to be monitored. Valid range is 2 to 8.

StackErrorNotificationInterval

Sets the interval between traps, in seconds. Valid range is 30 to 300.

Old Features Removed From This Release

None.

Problems Resolved in This Release

Ina stack of 2 units, the counters for GIG ports used 32-bit counters for the IfHCInOctets objects (Q00827524).

When downloading the configuration file of a stack of 470’s, the downloaded file over the TFTP server had a

slightly different size than the original. (Q01000623-02).

In a 470 stack, the non-base units did not use 64-bit counters (Q01148220-02).