Release Notes

Show stack-monitor command

The show stack-monitor command displays the status of the Stack Monitor feature.

The syntax for the show stack-monitor command is:

show stack-monitor

The

show stack-monitor command is in the privExec command mode.

A sample output of the show stack-monitor command:

470-24T#show stack-monitor

Status: disabled

Stack size: 2

Trap interval: 60

Stack-monitor command

The stack-monitor command enables the Stack Monitor feature.

The syntax for the stack-monitor command is:

stack-monitor [enable] [stack-size <2-8>]

[trap-interval <30-300>]

The stack-monitor command is in the config command mode.

Table 1 describes the parameters and variables for the stack-monitor command.

Table 1 stack-monitor command parameters and variables

Parameters and variables

Description

enable

Enables Stack Monitoring.

stack-size <2-8>

Sets the size of the stack to be monitored. Valid range is 2 to 8.

trap-interval <30-300>

Sets the interval between traps, in seconds. Valid range is 30 to 300.

Default stack-monitor command

The default stack-monitor command sets the Stack Monitor parameters to their default values.

The syntax for the default stack-monitor command is:

default stack-monitor [enable] [stack-size]

[trap-interval]

The default stack-monitor command is in the config command mode.

Table 2 describes the parameters and variables for the default stack-monitor command.

Table 2 default stack-monitor command parameters and variables

Parameters and variables Description

enable

Sets the Stack Monitor feature to disabled (the default state for the feature).

stack-size

Sets the size of the stack to be monitored to the default value: 2.

trap-interval

Sets the interval between traps to the default value: 60 seconds.

Note: If you do not specify a parameter for this command, all Stack Monitor parameters are set to their default values.