Release Notes

311708-A Rev 00
19
CR 121448-1: DHCP Server
In a configuration where several BootP interfaces are multinetted and a default
route is configured, the router will not use the “best” BootP interface as
configured with the MIB attribute wfBootpRelayIntfPri.
CR 121553-1: VRRP
When more than one unnumbered IP circuit is configured on a router slot,
interfaces configured with VRRP may stay in the initializing state.
CR 121599-1: VRRP
After a reboot of the router, a critical interface on a D100 board with a multinetted
VRRP interface does not forward traffic.
CR 121816-1: VRRP
In a configuration with VRRP on multinetted interfaces, the router may
experience faults during configuration or interface state changes.
CR 121955-1: NAT
The forwarding of traffic between one local NAT interface to another local NAT
interface is not permitted. The new MIB attribute wfNatBaseLocalToLocalEnable
addresses this issue. By default, wfNatBaseLocalToLocalEnable is set to Enable
to allow this traffic to go through. You can use the Technician Interface to change
this setting.
CR 122093-3: VRRP
After the router is running for 48 days, VRRP causes a multicast storm or stops
advertising.
CR 122505-1: MOSPF
When the FRE module in the OSPF soloist slot either is reinserted into the router
or reboots, a bus error occurs.
CR 122591-3: DVMRP
After a physical cable failure, a fault occurs in DVMRP on the router and it stops
sending out multicast traffic.
CR 122745-2: NAT
NAT does not translate the IP address contained in the TCP payload portion of the
FTP port command frame.