Release Notes

14
311708-A Rev 00
CR 118085-1: IGMP
The following IGMP error message appears in the log: “General query received
while still processing previous query.” This results in the upstream router deleting
the group.
CR 118147-1: Telnet
When a router is executing scripts over a Telnet connection, if the scripts are run
without any pause or delays and they port data to the session at an extremely fast
rate, a fault occurs.
CR 118218-1: ATM LANE
Continuously disabling and reenabling an ATM service record (or records) on a
single interface causes a tag violation and/or a master control processor error.
CR 118244-1: X.25
During router reboot, reset, or restart of X.25, a bus error occurs on either the local
or remote slot of a T1 connection.
CR 118273-1: FRE4/10_100_QENET
When you statically configure any port for 10 MB as half duplex or full duplex,
the 10/100 quad Ethernet network card exhibits performance inconsistencies.
CR 118310-1: Dial services
The router demand circuit (hot standby) stays up in the following sequence:
1.
The primary circuit goes down.
2.
The demand circuit is invoked.
3.
Before the demand circuit comes up, the primary circuit recovers and comes
up.
4.
The demand circuit comes up and continues to run.
CR 118481-1: ATM LANE
Resetting all or a subset of ATM service records may result in all or a subset of
these service records not recovering.
CR 118581-1: DECnet
The performance of DECnet and bridging over ATM LANE is poor.