Release Notes

311708-A Rev 00

CR 117118-2: Technician Interface

Due to security concerns about logins with User Access being able to access the

SNMP community strings configured on the router, logins with User Access are

now prevented from using the “type” command.

CR 117145-2: BGP

BGP reports routes to the Routing Table Manager with incorrect IP next-hop

information, causing routing loops.

CR 117191-1: FTP

When transferring the wellflt.log file using FTP, an FTP log message occurs

because of log wrap during log aggregation stating that “xx events lost on slot yy.”

In the log message, the event and slot numbers are transposed, causing the slot

number to appear to be an invalid value.

CR 117400-5: DVMRP

Deleting and re-creating a DVMRP interface results in a DVMRP circuit with a

“not present” state. Deleting the interface again causes a fault.

CR 117444-1: X.25

With PDN, PTOP, and IPEX service configured on a synchronous line, if you

open and close each X.25 service entry record on the DTE side, the following

warning message appears in the logs:

“Trying to free invalid timer descriptor.”

CR 117553-3: Frame relay

The frame relay startup delay timer is not reliably controlling the routing

convergence on unicast PVCs.

CR 117700-1: SW-SERV

If you configure a multichannel T1 interface for PPP/ISDN with

Bandwidth-on-Demand over Dial-on-Demand between two routers, and have one

side configured as Dynamic Monitor and the other as Multilink, disconnecting the

MCT1 line causes a bus error.

CR 117784-2: IPX

To be more helpful, a warning message for IPX due to a mismatch between

encapsulation and the configuration for encapsulation should also include the

circuit and the configuration encapsulation.