Release Notes

12
311708-A Rev 00
CR 115768-1: Multilink
A router interface configured with PPP Multilink reports an incorrect MIB II
wfIfEntry value when one link is up and the other is down.
CR 115989-1: IP
A bus error may occur when creating or deleting adjacent host entries.
CR 116120-2: ARP
An inverse ARP reply is ignored if the ARP source hardware address in the reply
packet differs from the ARP target hardware address field in the inverse ARP
request.
CR 116284-1: NAT
When you have two or more static mappings configured and delete the first
created NAT static mapping, the router faults.
CR 116433-1: Frame relay
On a router configured with frame relay PVCs and WAN Compression Protocol
(WCP), BayRS does not always set the discard eligible (DE) bit against low
priority traffic.
CR 116525-1: N/A
When using the Dumplog utility to convert a log file to text, the date after
12/01/99 is incorrect.
CR 116677-1: Technician Interface scripts
When you run the “show system info” command from the Technician Interface,
the show script displays negative numbers for the router up time.
CR 116691-1: MOSPF
After you run the “mtrace” tool on a router configured with MOSPF, the MOSPF
table contains non-multicast or other incorrect entries.
CR 116697-4: IPX
If you configure static routes for the same destination networks over two different
links with different costs to have a primary and secondary path, when the primary
link goes down, the route with the highest cost will not be inserted into the routing
table. These conditions can cause IPX connection problems.
CR 116853-1: Pktdump
The Pktdump utility (v1.3) places an incorrect date on the packet.