Release Notes

8
311708-A Rev 00
CR 110427-1: Filters
Invoking the “show ip traffic filter” command in the Technician Interface displays
incorrect information for the traffic filter fragments associated with the
wfIPTrafficFilterEntry MIB attribute.
CR 110565-1: Frame relay
On routers configured for frame relay multiline and the “AsyncStatusReport”
option enabled on the frame relay switch, adding VCs to the multiline circuits on
the switch causes a system error.
CR 111164-1: WCP
With WCP over ISDN MPPP Dial on Demand with Bandwidth on Demand, faults
may occur.
CR 111193-1: ARN
If wfSerialPortModemEnable is set to Enable on an ARN’s console port, a
memory leak occurs in the Technician Interface process. Note that this is an
unsupported option.
CR 111507-1: BGP
BGP peers are getting stuck in the Not Present state where they appear in the idle
state at one end, and in the connected state at the other end.
CR 112106-1: MOSPF
The router faults when the number of MOSPF forwarding entries exceeds 251.
CR 112123-1: DVMRP
DVMRP may fault when deleting a cache entry.
CR 112143-1: IGMP
If you disable a multicast circuit where an IGMP static group is configured, the
multicast protocol prunes the static group information so that traffic is not
forwarded. Then, if you reenable that DVMRP circuit, the router keeps pruning
traffic.
CR 112282-1: DVMRP
If you remove a downsteam neighbor, the router may fail to remove it from the
DVMRP pruned neighbor list, causing temporary data loss.
CR 112402-1: IPX
When IPX attempts to initialize, a bus error occurs on the router.