Release Notes

311708-A Rev 00
7
CR 109636-1: MOSPF
After adding the twenty-first IGMP static join entry, browsing the MOSPF
forwarding table or issuing the “show mospf fwd” command causes the router to
fault.
CR 109640-1: MOSPF
Invoking the “show mospf fwd” command does not show more than 13
downstream forwarding entries.
CR 109734-1: IP
ECMP fails to recover all paths when a link restarts when one or more paths are
over a PPP link.
CR 109842-1: ISDN
After dynamically configuring a standby circuit, the standby end remained active,
causing the upper layer protocols to also remain in an active state.
CR 109909-1: Boot
Booting the router multiple times either with a named boot file or by typing
“boot” causes orphan buffers in the log. Also, any router slots that do not contain a
flash card will stop loading protocols.
CR 109933-1: BGP
When you issue the “ip bgp_routes -N” command on interfaces with more than
four BGP peers, the network summary at the bottom is incorrect.
CR 110036-1: ATM
The router LEC is using the wrong parameters when placing control direct VCC
to LES.
CR 110148-1: OSPF
Enabling OSPF ASE metric support affects RIP external type 1 route
advertisements. This only affects static routes; directly connected routes function
correctly.
CR 110339-1: WCP
When WCP is configured, hardware compression does not function with a link
module 5431 ESAF-4 used together with a FRE2-060E.