Release Notes

311708-A Rev 00

CR 108776-1: DVMRP

A temporary data loss can occur when a prune is sent with an incorrect time value

that is smaller than the current prune time value.

CR 109126-1: FRE4/10_100_QENET

When you configure a 10/100-TX link module interface to support only

10BASE-T, even with no physical connection the router reports that the interface

is up.

CR 109173-1: X.25

The X.25 PAD does not recognize the “selection PAD command signal” when

caller user data is attached to the call message.

CR 109249-1: E7S

When the operating system is coming up, the QUICC driver does not initialize the

device correctly, causing a port 6 DTR/DSR error on E7S on an ARN.

CR 109269-1: SWSERV

SWSERV always answers an incoming call on the first ring, regardless of the

setting of S register 0 (S0 is the setting for the number of rings to receive prior to

answering the call) for Hayes mode.

CR 109386-1: ATM LANE

Under heavy LEARP traffic, an MCP error occurs on the ARE module.

CR 109399-1: ATM Half Bridge

When a packet contains data whose length is less than the minimum required for

Ethernet encapsulation, ATM half bridge does not pad the data to the minimum

length.

CR 109532-1: ARP

Setting the MIB parameter wfIpBaseArpBufLimitPrcnt to a value other than

100% causes the router to lose packets.

CR 109546-1: X.25

Using ISDB PAD, the echo back to the terminal server does not work when the

DTR Action entry is set to disable and the DTR is off.