User's Manual

Administering Avaya Video Conferencing Solution 6.1 Issue 1 89
DRAFT
Chapter 4: Administering video endpoints
This section describes the procedure to administer the actual endpoints to enable video
conferencing.
Administering video SIP endpoints
Avaya 1000 series video endpoints
Perform the following steps to configure all AVCS 1000 series video endpoints using the IR
Remote Control. The endpoint GUI may also be used for configuring the endpoint using a web
browser.
1. Log on to the video endpoint. The default password is 1234. Click the blue System Menu
Button on the remote. Select Admin Preferences by using the arrow buttons.
2. Navigate to Network > General, and set the following parameters:
● DHCP : Disabled. If DHCP is used, ensure the DHCP server is up and then select
DHCP : Enabled
● IP Address : The IP address assigned to the actual endpoint
● Subnet Mask : Appropriate entry
● Default Gateway : Appropriate entry
● Host Name : Appropriate entry
● DNS server : Appropriate entry
● Network Speed : Auto
● 802.1X Authentication : Disabled
3. Under Communications, click SIP, and set the following Parameters:
● SIP Username : <ext>
● Authorization Name : Same as SIP Username
● Authorization Password : Same as the Shared Communication Profile Password
● SIP registarion : Through Proxy
● SIP Proxy : Enabled
● Proxy Hostname : Session Manager FQDN or IP address used for registration. This
is the Session Manager Security Module / SIP Entity IP address or corresponding
FQDN.