User's Manual

86 Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011
● ARQ Required : Y
● Enable Layer 3 Test : N
● Far-end Node Name : the name entered for the RMX system.
● Far-end Listen Port : 1720
● Far-end Network Region: 1720
● Calls Share IP Signaling Connection : N
● Direct IP-IP Audio Connections : Y
● IP Audio Hairpinning : N
Configuring Polycom MGC Series Video Conferencing Systems
This section describes how to configure a Polycom MGC series video conferencing.The
following procedure.
Configuring IP Network Regions
On SAT, enter change ip-network-region n (where n is the chosen IP network region)
and set the following paramters:
● Intra-region IP-IP Direct Audio : Y
● Inter-region IP-IP Direct Audio : Y
● Security Procedures : any-auth
● codec set : appropriate entry
● Video Norm : appropriate bandwidth
● Video Prio : appropriate bandwidth
● Video Shr : Y/N, depending on if user wishes to share video pool.
Determining the Maximum Number of Video Conferencing Ports Supported
On the system-parameters customer-options screen verify the following parameters:
● verify Maximum Administered Ad-hoc Video Conferencing Ports. The maximum
number of Ad-hoc video conferencing ports allowed is the number of video ports
available for Ad-hoc use on the MCU(s). For example, if you have three MCUs, and
each MCU has 16 ports available for Ad-hoc use, the maximum number of Ad-hoc