User's Manual

Administering and setting up video H.323 endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 85
● the IP address of the C-LAN
Note:
Note: Make sure you have the RMX Installation and Configuration guide available when
you configure the RMX.
Adding an Entry in the IP Node Names for the RMX System
To add an entry in the IP Node Names screen for the RMX system, enter change
node-names ip to access the IP Node Names screen. Set the following parameters:
● Name : enter a name for the RMX system.
● IP Address : enter the IP address of the signaling host for the RMX system.
Adding a Two-Way Trunk Group for the RMX System
Enter add trunk-group n (where n is the chosen trunk group) and set the following
parameters.
● Group Type : ISDN
● Set Direction : two-way
● Carrier Medium : H.323
● Service Type : tie
Adding a Signaling Group for the RMX System
Enter add signaling-group n (where n is the chosen signaling group) and set the
following parameters:
● Group Type : H.323
● IP Video : Y
● Priority Video: Y. If you want all incoming calls to receive priority video transmissions.
● Trunk Group for Channel Selection : the two-way trunk added above
● Near-end Node Name: procr / C-LAN, For an S8300 system, you would enter
PROCR. For a port network, enter the name of the C-LAN board.
● Near-end Listen Port : 1720
● LRQ Required : N
● RRQ Required : Y