User's Manual

82 Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011
Note:
Note: Avaya one-X
®
Communicator uses the same pool of video licenses counted by
the Maximum Video Capable IP Softphones parameter. To provide video
softphone capability, you must have at least this number of Avaya one-X
®
Communicator licenses. Page 10 of this screen displays the number of Avaya
one-X
®
Communicator licenses you have.
Setting Up Video Endpoints
Perform this procedure if you want to allow priority video calling.
1. On SAT, enter change cos and set the following parameters:
● Priority Video Calling : appropriate COS levels.
2. To modify an existing station that uses Avaya one-X
®
Communicator, enter change
station n (where n is the number of the station you want to modify) and set the following
parameters:
● IP Softphone : Y
● IP Video : Y
For this station to make priority video calls, make sure you select a COS level that has Priority
Video Calling enabled. Repeat the above mentioned steps for each video-enabled Avaya
one-X
®
Communicator endpoint you want to configure.
Configuring Polycom VSX/HDX Series Video Conferencing
Systems and V500/V700 Video Calling Systems
Use this procedure to configure Polycom VSX/HDX series video conferencing systems and
V500 and V700 video calling systems.
Checklist
When setting up these systems, you will need to know the following information:
● maximum number of VSX/HDX, V500, and V700 systems on your network
● PIN for each VSX/V500/V700 system. The PIN can consist of a maximum of eight
numeric characters and is defined by the System Administrator.
● the key code that combines the Avaya option with any other Polycom options.