User's Manual

80 Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011
Adding a Signaling Group for the Video Trunk
To add a signaling group for the video trunk, enter add signaling-group n (where n is the
chosen signaling group) and set the following parameters:
● Group Type : H.323
● IP Video : Y
● Near-end Listen Port
● LRQ Required : N
● Far-end Node Name
● Far-end Listen Port
● Far-end Network Region : If you set the maximum bandwidth for video calls in Procedure
3, assign that IP network region calls Share IP Signaling Connection to Y
Note:
Note: You must set this parameter to Y.
● Set Direct IP-IP Audio Connections : Y
● Set IP Audio Hairpinning : Y
Adding a Trunk Group
To add a trunk group, enter add trunk-group n (where n is the chosen trunk group) and set
the following parameters:
● Group Type : ISDN
● Carrier Medium : H.323.
Go to page 5 of the Trunk Group screen and add members to the trunk group.
Modifying the Signaling Group
To modify the signaling group video trunk, enter change signaling-group n (where n is
the signaling group you added) and set the following parameters:
● Trunk Group for Channel Selection : the trunk group you just added.