User's Manual

Administering and setting up video H.323 endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 77
● RRQ Required : N
● Far-end Network Region : the appropriate IP network region
● Direct IP-IP Audio Connections : Y
● IP Audio Hairpinning : N
Adding an Inbound Trunk Group for the Gatekeeper
To add an inbound trunk group for the system, enter add trunk-group n (where n is the
chosen trunk group) and set the following parameters:
Group Type : ISDN
Carrier Medium : IP.
Go to page 5 of the Trunk Group screen and add members to the trunk group.
Modifying the Inbound Signaling Group
To modify the signaling group for the system, enter change signaling-group n (where n is
the signaling group you added in Procedure 6) and set the following parameters:
Trunk Group for Channel Selection : the trunk group added above
Adding an H.323 Video Signaling Group
Perform the following steps to add an H.323 video signaling group per endpoint managed by the
direct gatekeeper:
Enter add signaling-group n (where n is the chosen signaling group) and set the
following parameters:
Group Type : H.323.
LRQ Required : Y
RRQ Required : N
For endpoints that do not support third-party pause, place the signaling group in an IP network
region with direct-ip inter-region : disabled.
Modifying the Inbound Trunk Group
Modify the inbound trunk group to include one trunk member per endpoint managed by the
direct gatekeeper.