User's Manual

Administering and setting up video H.323 endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 75
On page 2 of the screen, set
● Allow Direct-IP Multimedia : Y
● Maximum Call Rate for Direct-IP Multimedia : This setting is the combined audio
and video transmit rate or receive rate for non-priority (normal) video calls. You can
use this setting to limit the amount of bandwidth used for normal video calls. For
example, if you select 384 Kbits, a maximum of 384 Kbits will be used to transmit and
to receive audio/video.
● Maximum Call Rate for Priority Direct-IP Multimedia : This setting is the combined
audio and video transmit rate or receive rate for priority video calls. You can use this
setting to limit the amount of bandwidth used for priority video calls. For example, if
you select 384 Kbits, a maximum of 384 Kbits will be used to transmit and to receive
audio/video.
To put the gatekeeper in its own network region, enter change ip-network-region n
(where n is the region number) and set the following parameters:
● Intra-region IP-IP Direct Audio : N
● Inter-region IP-IP Direct Audio : N
● Security Procedures 1 : any-auth
● Video Norm : the amount of bandwidth that you want to allocate for the normal video
pool to each IP network region.
● Video Prio : the amount of bandwidth that you want to allocate for the priority video
pool to each IP network region.
● Video Shr : Specify whether the normal video pool can be shared for each link
between IP network regions.
Adding an Outbound Signaling Group for the Gatekeeper
To add an outbound signaling group for the system, enter add signaling-group n (where n
is the chosen signaling group) and set the following parameters:
● Group Type : H.323
● IP Video : Y
● Priority Video: Y, if you want all incoming calls to receive priority video transmissions.
● Near-end Listen Port : 1719.
● LRQ Required : N
● RRQ Required : N
● Far-end Node Name : the name you entered for the system.
● Far-end Listen Port : 1719