User's Manual

Administering and setting up video SIP endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 69
Administering Avaya 1000 series and Avaya one-X
®
Communicator video endpoints and users using System Manager
This section describes how to use System Manager to create an endpoint template and how to
add users using these templates.
Creating a template for Avaya 1000 series and one-X
®
Communicator video
endpoints and users using System Manager
1. To create a custom template for any SIP endpoint on System Manager, click Elements >
Templates > Endpoint, select Communication Manager 6.0 on the Endpoint Templates
page and click New. Set the following parameters:
● Set Type : 9630SIP, an alias for the 1000 series endpoints
● Template Name : Avaya recommends naming the template according to its AV10x0
type and Communication Manager release, such as AV1010_CM_6_0.
● COR : 1
● COS : 1 or an appropriate cos group for priority video calling and bit-rate management
● SIP trunk : AAR or specific SIP trunk used between System Manager and
Communication Manager
2. Select the IP video check box.
3. To enable the Call Appearance feature, click Button Assignment, and set the main
buttons for each endpoint to call appr as follows:
● Avaya 1010 : 1
● Avaya 1020 : 1
● Avaya 1030 : 1
● Avaya 1040 : 3
● Avaya one-X
®
Communicator : 3
● Avaya 1050 : 7
Note:
Note: The call appearances must be set to the maximum limit permitted for each
endpoint.
4. Select the IP SoftPhone check box for Avaya one-X
®
Communicator. When you select this
check box, the title of the check box changes to IP Video SoftPhone.
5. Click Commit, and repeat this step for each endpoint.