User's Manual

68 Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011
Administering Avaya 1000 series video endpoints using System
Manager
This section describes the procedure to administer the Avaya 1000 series video endpoints
using System Manager.
1. To enable Multimedia IP SIP Trunking feature on Communication Manager System
Management Interface, log in to the Communication Manager System Management
Interface. Click Licensing > Administration and then navigate to the Feature
Administration page. Here, ensure the Multimedia IP SIP Trunking feature is set to YES.
2. To enable Multimedia IP SIP Trunking feature on the System Manager interface, click
Elements > Feature Management > Parameters > System Parameters - Customer
Options. Click the arrow icon next to the Select Device(s) from Communication Manager
List. From this list, select the appropriate Communication Manager, and then click Show
List.
3. On the same page, select the radio button in the first column and click View. Now, click
Next Page and ensure the feature Multimedia IP SIP Trunking is set to Y.
4. To enable video for the SIP signaling group, on System Manager, click Elements >
Feature Management > Network - Signaling Groups. On the Signaling Groups page,
click the arrow icon next to the Select Device(s) from Communication Manager List. From
the Communication Manager list, select the appropriate Communication Manager, and click
Show List. Select the appropriate Signaling Group Number and click edit to set
parameters as mentioned below:
● IP Video : Y
● Direct IP-IP Audio connections : Y
● Initial IP-IP Direct Media : Y
5. To identify the ip-codec-set, note the values of the Near-end Node Name and Far-end
Network Region. If the Near-end Node Name is set to PROCR, the listed value is used. If
the Near-end Node Name is set to C-LAN, enter list ip-interface-n (where n is the
slot location for C-Lan circuit pack) to find the correct C-LAN and make a note of the slot
value. These values are used to determine the IP Codec Set.