User's Manual

Administering and setting up video SIP endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 67
Administering Avaya 1000 series video endpoints using SAT
This section describes the procedure to administer the Avaya 1000 series video endpoints
using SAT.
1. On the Communication Manager SAT screen, enter change system parameters
customer-options and set the following settings:
● Multimedia IP SIP Trunking : Y
2. Enter change signaling-group n and set parameters as mentioned below:
● IP Video : Y
● Direct IP-IP Audio connections: Y
● Initial IP-IP Direct Media : Y
3. Note the values of the Near-end Node Name and Far-end Network Region.
4. If the Near-end Node Name is set to PROCR, the listed value is used. If the Near-end
Node Name is set to C-LAN, enter list ip-interface n (where n is the slot location
for C-Lan circuit pack) to find the correct C-LAN and make a note of the slot value. These
values are used to determine the IP Codec Set.
5. On the Communication Manager SAT screen, enter display ip-interface n and note
the value of the Network Region.
6. Enter change-ip-network-region and move to the Inter Network Region Connection
Management page. Ensure the dst rgn number aligns with the Far-end Network Region .
Make note of the codec set number.
7. Enter change ip-codec-set n, where n is the codec set number used by the SIP
signalling group. Add or change the appropriate audio codecs as required. Set the following
Multimedia parameters:
● Allow Direct-IP Multimedia : Y
● Maximum Call Rate for Direct-IP Multimedia : 1024 Kbits
Note:
Note: These values are examples only. 1024 allows for 720p High Definition. Higher
resolutions require more bandwidth.
● Maximum Call Rate for Priority Direct-IP Multimedia : 2048 Kbits.
Note:
Note: Ensure the list of audio codecs on the first page includes at least one of the audio
codecs supported by the video endpoint, such as G.722 or G.711.