User's Manual

Administering and setting up video SIP endpoints
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 63
Administering and setting up video SIP endpoints
Global Administration
1. On SAT, enter display system-parameters customer-options and verify the
following parameters:
● ISDN PRI :Y
● IP Trunks : Y
Note:
Note: You must log off and log back in to effect changes to System Parameters
Customer-Options screen.
2. On the System Parameters Customer-Options screen, navigate to and ensure the
Maximum Administered SIP Trunks field has a value that ranges between 0 and 800.
3. On the ip node names screen, Ensure all fields have values that are appropriate for your
network.
4. On SAT, enter change ip-network-map and enter the IP address and the host name
for the administered server on your network in the corresponding fields.
On the ip-network region screen to assign an IP network region for the SIP trunk. To administer
this correctly on theip-network region screen, the Network Region field on the ip-interface proc
screen needs to be the same as the Authoritative Domain below.
● Authoritative Domain : enter the SIP domain name for which this network region
applies.
● Intra-region IP-IP Direct Audio : Y
● Inter-region IP-IP Direct Audio : Y
5. On the Media Gateway screen, ensure the value for Network Region is the same as the
Network Region for the SIP authoritative domain.
6. On the IP Codec Set screen, ensure you have the right media compression for your SIP
endpoint types and other constraints.
Administering call routing
Before you can make SIP calls from endpoints that are connected to Communication Manager,
administer call routing properly in Communication Manager.
1. On the Feature Access Code screen set either the ARS Access code fields, or the AAR
Access code fields or both. To enable these fields, make sure that on page 5 of the System
Parameters Customer Options screen, Private Networking is set to Y.