User's Manual

Configuring Avaya Aura® Conferencing
Administering Avaya Video Conferencing Solution 6.0.1 Issue 2.1 April 15, 2011 57
● Units : NoLimit for each destination IP network region. You can set unlimited bandwidth or
use the bandwidth management option by restricting the bandwidth.
Repeat this procedure for each IP network region that will be used for video in this system.
Adding an Entry in the IP Node Names for the Conferencing System
Enter change node-names ip on SAT and set the following parameters:
● Name : a name for the Conferencing system
● IP Address : the IP address of the Conferencing Application server
Adding a Signaling Group for the Conferencing System
To add a signaling group for the Conferencing system, enter add signaling-group n (where
n is the chosen signaling group) on SAT and set the following parameters:
● Group Type : SIP
● Transport Method : tls /tcp
● IP Video : Y
● Priority Video : as appropriate.
● Near-end Node Name : enter PROCR or the name of the C-LAN board.
● Near-end Listen Port : 5061 or 5060
● Far-end Node Name : name you entered for the Conferencing.
● Far-end Listen Port : 5061 or 5060.
● Far-end Network Region : network region you specified for the Conferencing.
● Session Establishment Timer (min) : 120
● DTMP over IP : rtp-payload
● Enable Layer 3 Test : N
● Direct IP-IP Audio Connected : Y
Adding a SIP Trunk Group for the Conferencing
Enter add trunk-group n (where n is the chosen trunk group) on SAT and set the following
parameters:
● Group Type : SIP
● Group Name : name of the Conferencing
● COR : appropriate entry
● Direction : two-way.