Owner's Manual

1
2
3
4
6
6
EN
Ap pl ic at io n of c on ne ct or s an d co nt rol s
4. LPF – low pass filter 50 Hz -500 Hz (12 dB/Oct)
11. +12V – power supply terminal (+12V)
7. POWER - LED for operation (green)
5. CROSSOVER – selection of built-in filters operating mode (LPF, FLAT, HPF)
3. BASS BOOST – bass level adjustment 0/+6/+12 dB at 45 Hz
8. PROTECT - LED for protection (red)
6. HPF – high pass filter 50 Hz - 500 Hz (12 dB/Oct)
9. SPEAKERS OUTPUTS “+” – speakers positive terminal connections
2. GAIN – input signal level adjustment 0.2V - 6V
10. SPEAKERS OUTPUTS “-” – speakers negative terminal connections
12. REM – connector of remote activation of the amplifier
13. GND – grounding supply terminal «-»
1. INPUT – signal input, RCA jacks
7
5
12
11
10
9
8
13
10
9
The minimum permissible load impedance at the output of the amplifier is 2 ohm.
4 Ohm
8 Ohm
Se ri al c on ne ct io n of t he s pe ak er s
8 Ohm
16 Ohm
6. CONNECTION METHODS
In any case do not expose the amplifier to the loads lower than specified by the manufacturer. Use these schematics to
calculate load impedance of different connection types.