Owner's Manual

4
Use the table below to select the desired diameter based
on the length and the current consumption.
Use the table below to select the desired diameter based
on the length and the power consumption.
Selection of th e di am et er o f th e po wer cables
Selection of the diameter o f t h e s p e a k e r c a b l e s
EN
4. SELECTION OF THE DIAMETER OF POWER CABLES AND SPEAKER CABLES
240-350
180-240
150-180
120-150
100-120
80-100
60-80
40-60
20-40
8-20
0-8
0-1 1-2 2-3 3-4 4-5 5-6 6-7 7-8
53,5
33,6
21,2
8,4
5,3
3,3
2,1
1,3
0,8
1/0
2
4
8
10
12
14
16
18
A.W.G
mm²
Diameter
Cable length (m)
Consumption current (А)
20 000
25 000
15 000
10 000
8000
6000
4000
2000
1000
500
250
100
0-1 1-2 2-3 3-4 4-5 5-6 6-7
Cable length (m)
Power consumption (W)
7-8
16,8
8,37
5,26
2,08
5
8
10
14
A.W.G
mm²
Size
EN
5. WIRING DIAGRAMS
Connect the speaker cables from the positive and negative terminals of the speakers to the respective outputs of the amplifier
terminal marked with right / left speakers outputs as shown at the diagram. To connect the power wire supply it is necessary to
use special power cables. The fuse is placed in the holder and fixed in the cable cut. One end of the cable is connected to the
positive terminal of the battery, the second one – to the amplifier terminals marked with +12V. Be sure to use a fuse with the
parameters sufficient for use in the system. The length and diameter of the grounding cable must conform to the length and
diameter of the cable +12V. Connect one end to the negative terminal of the battery and the other end of the grounding cable to
the terminals marked with GND. Connect the head unit (HU) to low-level inputs of the amplifier using RCA cable.
Step 2. Connect the speaker cable from (-) terminal of the amplifier to (-) terminal of the speaker.
Step 1. Connect the speaker cable from (+) terminal of the amplifier to (+) terminal of the speaker.
Standard wiring diagram of two-channel amplifier to two speakers.
2-8 Ohm
2-8 Ohm
Caution!!! The minimum permissible connection load impedance at every single channel is 2 ohm.
For model ABR-200.2 the operating voltage is 9-15V.