INSTALLATION GUIDE Tools Required EN Phillips Flat blade | . . screwdriver screwdriver Pliers Wire Strippers Electrical | Power Drill 94D Bit | tape \ (optional) (optional) J If mounting to a support structure, you will also need these tools. If there is no existing mounting box, then read the following instructions. Disconnect the power by removing the fuses or by turning off the circuit breakers. Secured the outlet box directly to the building structure. Use appropriate fasteners and building materials.
1.Hanger Options A a. Installing the mounting bracket Step 1. Pass the power wires through the hole in the mounting bracket as shown in Fig.l. Step. Secure the mounting bracket to the ceiling outlet box with the wood screws and flat washer provided with your outlet box. b.
2.Hanging Motor housing Lift the Motor housing and hang it on the hook of the mounting bracket. mounting bracket Motor housing 3.Wiring (continued) FROM RECEIVER FROM CEILING FROM FAN white I whi — white white [i He black if black ! blue blue (Fig.5) © Connect the 2 grounding wires (green, green/yellow stripe, or bare copper) coming from the ceiling, down rod, and hanger. © Connect the white wire from the receiver to the white wire from the fan.
.The controller installation Put the controller in the Motor housing after the wire is connected stroller Motor housing (Fig.6) 5.Installing Motor housing Remove the motor housing from the hook and align it with the mounting bracket hole of the suspension plate and tighten it with S Crews. mounting bracket Motor housing (Fig.7) 6.Attaching the Fan Blades Place each blade between a blade iron and medallion.
7. Blade assembly installation © Remove blade iron screws from fan motor ® Attach the blade irons to the motor with blade iron screws © Repeat this step for each blade assembly fan motor blade iron screw (Fig.9} 8. Switch housing installation © Feed the wire through the center hole of the switch housing © Attach the switch housing to the motor with screws (Fig.10) 9. The LED installation © Connect the wire from fan to LED.
10. The lampshade installation Bend the lampshade properly and then put it in the switch housing. switch housing: lampshade ok (Fig.
