User's Manual

 Use only supplied and approved charger.
 Replacement or service must be done by qualified service center or manufacturer.
 Unplug this device when unused for long periods of time or during lightning storms.
CAUTIONS: ELECTRIC SHOCK HAZARD
The battery used in this device may present a risk of fire or chemical burn if mistreated.
9. Declaration of Conformity
9.1. FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for ANY interference, for example RADIO or TV interference, caused by unauthorized
modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
9.2. EU
This product is CE certified according to the provision of the R&TTE Directive (99/5/EC).
Declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
9.3.
RF Warning Statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition
without restriction. Changes or modifications not expressly approved by the party responsible for compliance. Could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
9.4. Trademark Statement
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc.
Avantalk is a trademark owned by Avantronics limited.
10. Warranty
Please refer the warranty card included in the pack.
Online Tutorial & Technical Support
More information about this product and other Avantalk Bluetooth products, including the video user guide, product tutorial and
online technical support, please refer to www.avantalk.com website.
Due to software update, there could be some changes on operations. Please always refer to Product Tutorial page in Avantalk
website for the latest features.
Z-PKMN-AS6-0000